Montana Code Annotated 1997

MCA ContentsSearchPart Contents


     82-4-203. Definitions. Unless the context requires otherwise, in this part, the following definitions apply:
     (1) "Abandoned" means an operation in which a mineral is not being produced and that the department determines will not continue or resume operation.
     (2) (a) "Alluvial valley floor" means the unconsolidated stream-laid deposits holding streams where water availability is sufficient for subirrigation or flood irrigation agricultural activities.
     (b) The term does not include upland areas that are generally overlain by a thin veneer of colluvial deposits composed chiefly of debris from sheet erosion, deposits by unconcentrated runoff or slope wash, together with talus, other mass movement accumulation, and windblown deposits.
     (3) "Aquifer" means any geologic formation or natural zone beneath the earth's surface that contains or stores water and transmits it from one point to another in quantities that permit or have the potential to permit economic development as a water source.
     (4) (a) "Area of land affected" means the area of land from which overburden is to be or has been removed and upon which the overburden is to be or has been deposited.
     (b) The term includes:
     (i) all land overlying any tunnels, shafts, or other excavations used to extract the mineral;
     (ii) lands affected by the construction of new railroad loops and roads or the improvement or use of existing railroad loops and roads to gain access and to haul the mineral;
     (iii) processing facilities at or near the mine site or other mine-associated facilities, waste deposition areas, treatment ponds, and any other surface or subsurface disturbance associated with strip mining or underground mining; and
     (iv) all activities necessary and incident to the reclamation of the mining operations.
     (5) "Bench" means the ledge, shelf, table, or terrace formed in the contour method of strip mining.
     (6) "Board" means the board of environmental review provided for in 2-15-3502.
     (7) "Coal conservation plan" means the planned course of conduct of a strip- or underground-mining operation and includes plans for the removal and use of minable and marketable coal located within the area planned to be mined.
     (8) (a) "Coal preparation" means the chemical or physical processing of coal and its cleaning, concentrating, or other processing or preparation.
     (b) The term does not mean the conversion of coal to another energy form or to a gaseous or liquid hydrocarbon, except for incidental amounts that do not leave the plant, nor does the term mean processing for other than commercial purposes.
     (9) "Coal preparation plant" means a commercial facility where coal is subject to coal preparation. The term includes commercial facilities associated with coal preparation activities but is not limited to loading buildings, water treatment facilities, water storage facilities, settling basins and impoundments, and coal processing and other waste disposal areas.
     (10) "Contour strip mining" means that strip-mining method commonly carried out in areas of rough and hilly topography in which the coal or mineral seam outcrops along the side of the slope and entrance is made to the seam by excavating a bench or table cut at and along the site of the seam outcropping, with the excavated overburden commonly being cast down the slope below the mineral seam and the operating bench.
     (11) "Degree" means a measurement from the horizontal. In each case, the measurement is subject to a tolerance of 5% error.
     (12) "Department" means the department of environmental quality provided for in 2-15-3501.
     (13) "Failure to conserve coal" means the nonremoval or nonutilization of minable and marketable coal by an operation. However, the nonremoval or nonutilization of minable and marketable coal that occurs because of compliance with reclamation standards established by the department is not considered failure to conserve coal.
     (14) "Fill bench" means that portion of a bench or table that is formed by depositing overburden beyond or downslope from the cut section as formed in the contour method of strip mining.
     (15) "Imminent danger to the health and safety of the public" means the existence of any condition or practice or any violation of a permit or other requirement of this part in a strip- or underground-coal-mining and reclamation operation that could reasonably be expected to cause substantial physical harm to persons outside the permit area before the condition, practice, or violation can be abated. A reasonable expectation of death or serious injury before abatement exists if a rational person, subjected to the same conditions or practices giving rise to the peril, would not willingly be exposed to the danger during the time necessary for abatement.
     (16) "Marketable coal" means a minable coal that is economically feasible to mine and is fit for sale in the usual course of trade.
     (17) "Method of operation" means the method or manner by which the cut, open pit, shaft, or excavation is made, the overburden is placed or handled, water is controlled, and other acts are performed by the operator in the process of uncovering and removing the minerals that affect the reclamation of the area of land affected.
     (18) "Minable coal" means that coal that can be removed through strip- or underground-mining methods adaptable to the location that coal is being mined or is planned to be mined.
     (19) "Mineral" means coal and uranium.
     (20) "Operation" means:
     (a) all of the premises, facilities, railroad loops, roads, and equipment used in the process of producing and removing mineral from and reclaiming a designated strip-mine or underground-mine area, including coal preparation plants; and
     (b) all activities, including excavation incident to operations, or prospecting for the purpose of determining the location, quality, or quantity of a natural mineral deposit.
     (21) "Operator" means a person engaged in:
     (a) strip mining or underground mining who removes or intends to remove more than 10,000 cubic yards of mineral or overburden;
     (b) coal mining who removes or intends to remove more than 250 tons of coal from the earth by mining within 12 consecutive calendar months in any one location;
     (c) operating a coal preparation plant; or
     (d) uranium mining using in situ methods.
     (22) "Overburden" means:
     (a) all of the earth and other materials that lie above a natural mineral deposit; and
     (b) the earth and other material after removal from their natural state in the process of mining.
     (23) "Person" means a person, partnership, corporation, association, or other legal entity or any political subdivision or agency of the state or federal government.
     (24) "Prime farmland" means land that:
     (a) meets the criteria for prime farmland prescribed by the United States secretary of agriculture in the Federal Register; and
     (b) historically has been used for intensive agricultural purposes.
     (25) "Prospecting" means:
     (a) the gathering of surface or subsurface geologic, physical, or chemical data by mapping, trenching, or geophysical or other techniques necessary to determine:
     (i) the quality and quantity of overburden in an area; or
     (ii) the location, quantity, or quality of a mineral deposit; or
     (b) the gathering of environmental data to establish the conditions of an area before beginning strip- or underground-coal-mining and reclamation operations under this part.
     (26) "Reclamation" means backfilling, subsidence stabilization, water control, grading, highwall reduction, topsoiling, planting, revegetation, and other work to restore an area of land affected by strip mining or underground mining under a plan approved by the department.
     (27) "Remining" means conducting surface coal mining and reclamation operations that affect previously mined areas (for example, the recovery of additional mineral from existing gob or tailings piles).
     (28) (a) "Strip mining" means any part of the process followed in the production of mineral by the opencut method, including mining by the auger method or any similar method that penetrates a mineral deposit and removes mineral directly through a series of openings made by a machine that enters the deposit from a surface excavation or any other mining method or process in which the strata or overburden is removed or displaced in order to recover the mineral.
     (b) For the purposes of this part only, strip mining also includes remining and coal preparation.
     (c) The terms "remining" and "coal preparation" are not included in the definition of "strip mining" for purposes of Title 15, chapter 35, part 1.
     (29) "Subsidence" means a vertically downward movement of overburden materials resulting from the actual mining of an underlying mineral deposit or associated underground excavations.
     (30) "Surface owner" means:
     (a) a person who holds legal or equitable title to the land surface and whose principal place of residence is on the land;
     (b) a person who personally conducts farming or ranching operations upon a farm or ranch unit to be directly affected by strip-mining operations or who receives directly a significant portion of income, if any, from farming or ranching operations; or
     (c) the state of Montana when the state owns the surface.
     (31) "Topsoil" means the unconsolidated mineral matter that is naturally present on the surface of the earth, that has been subjected to and influenced by genetic and environmental factors of parent material, climate, macroorganisms and microorganisms, and topography, all acting over a period of time, and that is necessary for the growth and regeneration of vegetation on the surface of the earth.
     (32) "Underground mining" means any part of the process that is followed in the production of a mineral and that uses vertical or horizontal shafts, slopes, drifts, or incline planes connected with excavations penetrating the mineral stratum or strata. The term includes mining by in situ methods.
     (33) "Unwarranted failure to comply" means:
     (a) the failure of a permittee to prevent the occurrence of any violation of a permit or any requirement of this part because of indifference, lack of diligence, or lack of reasonable care; or
     (b) the failure to abate any violation of a permit or of this part because of indifference, lack of diligence, or lack of reasonable care.
     (34) "Waiver" means a document that demonstrates the clear intention to release rights in the surface estate for the purpose of permitting the extraction of subsurface minerals by strip-mining methods.
     (35) "Written consent" means a statement that is executed by the owner of the surface estate and that is written on a form approved by the department to demonstrate that the owner consents to entry of an operator for the purpose of conducting strip-mining operations and that the consent is given only to strip-mining and reclamation operations that fully comply with the terms and requirements of this part.

     History: En. Sec. 3, Ch. 325, L. 1973; amd. Sec. 1, Ch. 209, L. 1974; amd. Sec. 1, Ch. 235, L. 1974; amd. Sec. 16, Ch. 441, L. 1975; amd. Sec. 1, Ch. 538, L. 1975; R.C.M. 1947, 50-1036; amd. Sec. 2, Ch. 550, L. 1979; amd. Sec. 1, Ch. 437, L. 1981; amd. Sec. 1, Ch. 70, L. 1987; amd. Sec. 1, Ch. 147, L. 1991; amd. Sec. 1, Ch. 225, L. 1993; amd. Sec. 1, Ch. 159, L. 1995; amd. Sec. 367, Ch. 418, L. 1995; amd. Sec. 2, Ch. 196, L. 1997.

Previous SectionHelpNext Section
Provided by Montana Legislative Services